📁 last Posts

Why Do Smartphone Batteries Weaken Over Time

Why Do Smartphone Batteries Weaken Over Time

The batteries of Smartphone as any other rechargeable battery deplete with usage but mainly because of the process of charging and discharging. The drive cycle shown in the figure is that every battery has only a limited number of those cycles and as the above figure shows, as the battery cycles increase the ability of a battery to retain charge decreases. This gradual loss is actually normal with battery chemistry.  

Another assignable cause of battery degradation is heat. If you use or store your device in hot environments, then the chemical reactions within the battery deteriorate and wear out quickly. Prolonged usage and overcharging of the battery deteriorates it rapidly as well as during intensive usage.  

Remaining fully charged or plugged in after being fully charged is also a bad thing for battery health. Both of these practices create additional stress on the battery cells and therefore decrease the efficiency of the battery cells. This is worsened by non-certified chargers which may lead to irregular voltage flow.  

That would be how often, or the ideal conditions in charging your device, which include charging when the capacity of the battery is between twentieth and eightieth percent as well as the avoidance of extreme temperatures. Avoid using copied chargers or allow the battery to drain flat. These few small changes can dramatically improve the longevity of your battery.  

Update your device is also very bearing fruit when it comes to avoiding cyber criminals attacks. Some updates contain settings intended to conserve battery charge. There are certain measures you take that could help you maintain your smartphone battery reliable for many years to come.  

Reasons for Battery Degradation

1. Charging and Discharging Cycles

All batteries are designed with an input of the overall number of charge and discharge cycles possible. The daily cycling of the battery gradually decreases the battery charge capacity so that after the battery has been fully cycled for a long period of time, the performance of the battery is quite poor.

2. High Temperatures

High temperatures are also bad for batteries since they cause undesirable chemistry processes inside of them to speed up. Heat also dramatically reduces the remaining power no matter if you were charging your device and using it in hot temperature or it was stored in warm temperature.

3. Continuous Charging

Charging your device for many hours and then leaving it plugged in after it is full only puts added pressure on the battery cells. Such pressure can cause a steady degrading of the battery capacity and shorten battery lifetime.

4. Using Non-Certified Chargers

That means cheap chargers have fluctuations in voltages and this will end up damaging the battery system. Charging the laptops with appropriate charger brand enhances the battery life of the laptops.

5. Fully Draining the Battery

It puts pressure on the internal cells of the battery when an attempt is made several times to charge it once it has been drained out to the last level. This habit results in faster rate of discharge of battery capacity and shorter battery lifespans.

In order to carry out this article I have used several tips that will help in preserving the battery efficiency

1. Avoid Excessive Heat

Heat, on the other hand, you can kill your battery very fast. Do not expose the device to high temperatures – store and use it in reasonable temperatures avoiding extreme heat.

2. It must be charged with in reasonable measure

It has been found that charging your battery to about 20% and then discharging it to about 80 % is best for the longevity of the battery. However a few words of advice, do not always bring it up to a hundred percent.

3. Use Original Chargers

That is why you should only use the chargers certified by the manufacturer to avoid fluctuations in the voltage and have safe charging. Like all batteries, non-certified chargers can damage the battery in the long-run.

4. Check for Software Updates

Maintaining software on your device can make batter management better by providing updates. Such updates may contain some settings to relate to power consumption and enhance the consumption rate.

5. Enable Power Saving Mode

This mode dims background, reducing energy usage, and making the battery, particularly on devices with heavy use, to last longer.

Adhering to these guidelines will help you keep your battery healthy and work efficiently for use of your device.

Achaoui Rachid
Achaoui Rachid
Hello, I'm Rachid Achaoui. I am a fan of technology, sports and looking for new things very interested in the field of IPTV. We welcome everyone. If you like what I offer you can support me on PayPal: https://paypal.me/taghdoutelive Communicate with me via WhatsApp : ⁦+212 695-572901
Comments